The TX Series 24 inch L.C. Series of Industrial Pneumatic Forklifts were designed and engineered with emphasis on operator and service personnel at the forefront. The TX Series provides standard features like increased leg room and head room, tilt steering wheel, shock mounted center mounted operator station, CANbus technology for operator comfort and convenience and increased leg and head room, in addition to fingertip electric joystick controls. The TX Series is available in 5 different wheel bases, so there is certainly a model suitable for your specific use.
All controls on the equipment are integrated utilizing solid state controllers with J1939 CANbus technology. This set up allows sensors and controllers the ability to communicate with minimal wiring between the components. Like for instance, I/O modules are great to add consistency to the control system of the equipment and utilized to eliminate electromechanical relay devices.
Located in each and every cab is the main color display which access the information from the J1939 CANbus technology. This particular display shows engine data along with warnings, spreader status lights and man and equipment interface data. The equipment functions could be tuned through the main display inside the cab. What's more, the display enables service employees to access information required while troubleshooting. Like for instance, information like sensor status and controller outputs. So as to avoid operator access, the tuning functions are password protected.
Each unit within the TX Series line of forklifts uses an electronic turbocharged Tier Certified Cummins, after-cooled or charge air to air diesel engine. Some of the basic engine features include electronic diagnostic monitor, maintenance monitor, water/fuel separator, transmission/engine protection systems, reduced emissions and better fuel economy.
The transmission on all TX Series are 3-speed, fully reversing, modulated powershift transmissions. The inching powershift transmission and the electric roll shift control as well as a separate air-to-oil cooler. All of these features make an efficient and strong equipment which is extremely dependable on the jobsite.
|
|
